baseline correction

Home > Forums > jMRUI Software > General support > baseline correction

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #2234
    Milena Lai
    Participant

    Hello, how do I go about doing baseline correction in the 6.0 version? In the manual it is under preprocessing steps but in the 6.0 version it doesn’t seem to be there so I wasn’t sure if it is under another name?

    #2235
    W. Kim
    Participant

    Hi Milena

    In the quantitation step, you can do baseline correction.

    for example, in QUEST ‘overphase’ tap, there is ‘how many truncate points?’ blank…in below of window

    i usually input 20 points.

    thanks

    #2246

    What about if we are using AMARES? Is there any guideline on how many points to truncate at 3T? A lot of this is visual judgment but that can cause some error.
    Thanks.

    Pallab Kumar Bhattacharyya
    The Cleveland Clinic Foundation

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.